There are many kinds of interface methods for new energy vehicle RF connectors, which can usually be divided into two types: RF connectors (connected with cables) and RF connectors (connected with printed circuit boards). Riveting and pressing are the most commonly used interface methods in the two types. This means that the Chinese of these two interface methods can be expressed by the word riveting pressure. The definition of pressing into the RF connector is to press the pin (also known as the terminal) into the hole smaller than the thickness under the action of external force. Due to the low cost, efficiency, ease of use, high stability, communication and computer fields with SMT (that is, surface installation technology is a kind of connection technology).

With the continuous improvement of the level of car intelligent systems, in addition to the original car engine intelligent management system and other machines and equipment that require radio frequency connectors for data connection, more and more car multimedia, driverless system software, etc. are connected to radio frequency. The requirements of the device are becoming more and more obvious.